An error occurred while validating 80004005 Nylons sex chat no credit card

Tick the box at the very bottom: "Deploy this image from the PXE enabled Distribution Point".

I would assume you already did that for standard PXE booting.) If there's no issues with which DP is in use, then I'd say remove the DP completely and then add it back again and configure it as required.

Mike I have an older SCCM 2007 that is in the boundary group, but the PXE is not point to that server.

My IP HELPER is point to my new SCCM 2012 R2 server for PXE.

I am trying to run an OSD to a bare metal to a new Dell Latitude 7370 using a PXE boot via USB docking station.

I successful boot to Win PE, but U get an error "This computer is not registered with System Center Configuration Manager 2012 R2" This is the first Latitude 7370 I am trying.

I see the machine in the collection and see that it does have the TS assigned to it under the deployment tab.

I also have an Opti Plex 7040 that does not have this happen to it.

In use, you boot with the same boot media or PXE the same way, but the machine must be completely new to CM for it to work.

So the MAC address that is seen during the PXE is the AUX MAC for the computer.

Which is what I imported into the SCCM, but the MAC on the USB Dock and USB adaptor are not using the AUX MAC.

You therefore need to delete any machine objects that exist for any and all machines that you want to treat as "unknown".

Also you need to think about your Group Discovery Method as if it scans AD just before you boot the machine will be *back* in the console, and so won't work.

Leave a Reply